3D Joined Hearts Letter Holder or Suncatcher
Copyright 2007 GlassSorcery.com

Use reds, pinks, whites, or textured clears. Area where hearts overlap should reflect merging of heart colors. Shown here in Spectrum 1901W, 307S, 152W, and Uroboros 00-294.
Directions: 
1. Cut two of each rectangle and one of Joined Hearts. 
2. Wrap all glass pieces with foil. If desired, wrap one rectangle with wider foil and use this as the base piece.
4. Solder the Joined Hearts section.
5. Place base rectangle on work surface. Construct as for a basic box, placing Joined Hearts on one long side of base and plain large rectangle on opposite long side. Place small rectangles at each end. Tack solder all pieces.
5. Solder all inside and out.
6. Clean. Patina if desired. Apply protective wax.